Recent content by MrChubbyHubby

I bought a '06 Unlimited to compliment my 95 YJ (its for sale), and I would like to hardwire my XM to the stock CD / Radio. Has anyone had this done yet? Also, where did you place the antenna? Seems like finding a good place will be tough w/ a soft top. I guess I could place a magnet under...

RE: New girl in town Thanks. I also noticed upon a closer inspection, that some of the black paint from the hardhop is a little scratched. Whats the best thing to touch it up with without costing me an arm and a leg? It's a CJ-7 fiberflass top.

Its finally cold here in Tampa and I need to put my hard top back on. I remember my Jeep being a lot noisier (over bumps, potholes, RR crossings) when the hardtop was on last spring. Would weather stripping between the top and the jeep help this racquet? Thanks for any inputs.

Hey Guys. I need help. I have a 95YJ w/ 2.5L. About 50 miles ago I started hearing an ever so slight "chatter". It has gotten so loud that I am afraid to drive it and would call it a "rapping" in gears 2 thru 5 at this point (may be too suble in 1st gear). It starts at about 1500rpm and...

Thanks for the constructive comments. Next time I will be sure to proofread my post to reflect proper gears. I'll also make sure I document that I am in need of a manual so I was not able to look for the info myself. I am sure manual would tell me the info I am looking for.

Fuel Pump Hey.... My 95 YJ has the stock 2.5l in it. What was the maxinum towing wieght out of the factory? I do have 4.65 gears in it though... Would that allow me to tow a little more? I have a large utility trailer (1400lbs empty), and when I fill it full of tree branches it gets to...

I am in Sunny Florida. I guess a good 10W40 will work fine. Thanks for the repsonses.

Hey..... whats the choice oil and weight in my 95 w/ 4 cyl???

Since I bought this thing, the Oil Pressure Gauge has not worked right. When I start the Jeep up, it takes about 3 seconds for the gauge to peg to the right above 80. The needle never moves until I shut it down. Here are my questions: Is the OP Sensor located on the left side of the motor...

Well.... If I get in there... I want to do bearings and everything on both sides... and I just dont have the time right now to spend on that.

np207 Those tires I believe are Q78-15 's.... Which correct me if I am wrong is the old tire measuring system... I think they translate to 35.5's. They are Gateway Buck Shot mudders.... Are they any good????? Also when I bought it it came with a set of BF Goodrich 33x12.50 - 15's...

Thanks. I put fluid (80W90) in it last night. I was about 1/2 quart low. I guess I will have to keep an eye on it. Thanks again. Getting this "figured out allows me to worry about other stuff (Like the post I will post in a few minutes regarding oil pressure).

Hey... I noticed over the past week that my front right axle seal is leaking a bit. I simply dont have a free time any time soon to put a in new seal. I am going to put new bearings in there too as long as I am in there. I would rather do it once and do it right. Anyways, I am sure I have...

Grease / Oil / Dirt buildup If not Camo.... then what color???? Dark Blue.... Dark Green???

Last night I noticed that there is tons of garbage built up on the under side. I just want to make sure I wont damage anything by hitting it with some degreaser or engine cleaner. Can I hurt anything???